Home > News > Content

Common Hydraulic Pump Fault Analysis

Mar 07, 2025

Although there are various types of hydraulic pumps, their working principles and functions are similar. Therefore, hydraulic pumps can be studied as a distinct object. Based on an investigation and analysis of common faults in various hydraulic pumps during operation, the following common faults are summarized: 

1. No Oil Output or Pressure

When a hydraulic pump does not output oil or lacks pressure, the entire hydraulic system will be unable to function, impacting system efficiency. The causes include:

  • Mismatch between the prime mover and the hydraulic pump rotation direction.
  • Low oil level in the tank.
  • Blockage in the suction pipe or oil filter.
  • Low speed during startup.
  • Excessive oil viscosity or inflexible blade movement.
  • Air leakage at the oil inlet.
  • Loose assembly screws.           

2. Insufficient Flow or Pressure Cannot Increase

When the hydraulic pump has insufficient flow and pressure, it leads to unstable speed and pressure of the actuators, preventing external work. Therefore, it is necessary to identify the causes and stabilize flow while increasing pressure. The reasons for insufficient flow or pressure may include:

  • Partial blockage in the suction pipe or oil filter.
  • Poor sealing at the suction end connection, allowing air to enter; suction position is too high.
  • Loose pump cover screws.
  • System leakage.
  • Excessive axial and radial clearance in the gear pump.
  • Wear on the inner surface of the vane pump stator.
  • Wear between the piston and cylinder body or between the distribution plate and cylinder body, insufficient or inability to return the piston, leading to loss of sealing between the cylinder body and distribution plate.
  • Malfunction of the variable mechanism in the piston pump.
  • Severe wear on the side plate, increasing leakage.
  • Malfunction of the pressure relief valve.                

3. Severe Noise and Pressure Fluctuation

Severe noise and pressure fluctuations significantly affect the performance of the hydraulic system and the working environment. The causes include:

  • Partial blockage in the suction pipe or oil filter.
  • Poor sealing at the suction end connection, allowing air to enter; suction position is too high.
  • Air entering from the pump shaft oil seal.
  • Loose pump cover screws.
  • Misalignment or looseness between the pump and coupling.
  • Excessively high oil viscosity, with bubbles in the oil.
  • Insufficient flow capacity of the suction inlet filter.
  • Excessively high rotational speed.
  • Blockage in the pump body cavity.
  • Excessively small axial clearance in the gear pump, with deviations in perpendicularity of the gear bore and end face or parallelism of the two holes on the pump cover, leading to blockage of the pressure relief valve damping hole.

4. Overheating

The main causes of hydraulic pump overheating are:

  • Excessively high or low oil viscosity.
  • Serious friction between the side plate and the shaft sleeve with the gear end face.
  • Poor oil cleanliness, leading to increased internal wear, reduced volumetric efficiency, and heat generation from internal leakage.
  • Insufficient tank volume, resulting in poor heat dissipation.
  • System overload, primarily manifested as excessively high pressure or rotational speed.

5. Leakage

The amount of leakage in a hydraulic pump directly determines the output flow rate, affecting the stability of the hydraulic system's speed and the size of the output power. The main causes of leakage are:

  • Damage to the center spring of the piston pump, resulting in a loss of sealing between the cylinder body and distribution plate.
  • Damage to oil seals or sealing rings.
  • Poor sealing surfaces.
  • Wear between internal components of the pump, leading to excessive clearance.
Send Inquiry