As we all know, the engine is the heart of the car, and there are some small parts in the engine to ensure the normal operation of the car engine. The engine connecting rod is one of them. It plays a vital role in the engine, so why does such a small part play such an important role. The following are some knowledge points about the connecting rod of the car engine, hoping to help everyone understand it.

Fanghe Machinery
1. The structure and function of the connecting rod
The connecting rod is a slender non-circular cross-section variable rod, whose shaft section gradually decreases from the large end to the small end to adapt to the sharply changing dynamic load. It consists of three parts: the connecting rod big end, the shaft and the connecting rod small end. The large connecting rod end is separated. One half is integrated with the shaft, and the other half is integrated with the connecting rod cover. The connecting rod cover is assembled with the crankshaft main journal by bolts and nuts. The connecting rod connects the piston and the crankshaft, and transmits the force of the piston to the crankshaft, converting the reciprocating motion of the piston into the rotational motion of the crankshaft.
It is one of the main transmission parts of the automobile engine, which transmits the pressure of the expanding gas on the top of the piston to the crankshaft, so that the reciprocating linear motion of the piston becomes the rotational motion of the crankshaft to output power.
2. Workpiece materials and blanks
Most of the connecting rod materials are high-strength materials such as 45 steel and 40Dr steel, and are quenched and tempered to improve cutting performance and improve impact resistance. The hardness requirement of 45 steel is HB217~293, while the requirement of 40Dr is HB223~280. There are also ductile iron and powder metallurgy technologies to reduce the blank cost of the connecting rod.
The blank of the steel connecting rod is usually produced by forging. There are two forms: one is to forge the body and the cover separately. The other is to forge the body and the cover into one body, and then cut or use expansion during processing.
In addition, in order to avoid defects in the connecting rod blank, hardness measurement and defect detection are required.






