Home > Blog > Content

How to process connecting rods

Nov 22, 2024

 

Connecting rods are important components of gasoline engines and diesel engines, and there are many types and huge quantities. Among them, the demand for automobile engines is relatively large. Today, I will take you to learn about the relevant knowledge of connecting rods.

Fanghe Machinery

1. Structure and function of connecting rods

The connecting rod is a slender non-circular rod with a variable cross-section, and its shaft cross-section gradually decreases from the large end to the small end to adapt to the rapidly changing dynamic loads during work. It consists of a connecting rod big end, a shaft and a connecting rod small end. The large connecting rod end is separated, half is integrated with the shaft, and the other half is the connecting rod cover. The connecting rod cover is assembled with the crankshaft main journal by bolts and nuts.

The connecting rod connects the piston and the crankshaft, and transmits the force applied by the piston to the crankshaft, converting the reciprocating motion of the piston into the rotational motion of the crankshaft. It is one of the main transmission components of the automobile engine, which can transmit the pressure of the expanding gas on the top of the piston to the crankshaft, so that the reciprocating linear motion of the piston becomes the rotational motion of the crankshaft to output power.

方和机械

Fanghe Machinery

Second, the workpiece material and blank of the connecting rod

Most connecting rods are made of high-strength 45 steel, 40Dr steel, etc., and are quenched and tempered to improve cutting performance and improve impact resistance. The hardness of 45 steel is HB217-293, while the hardness of 40Dr is HB223-280. There are also ductile iron and powder metallurgy technologies that can reduce the cost of blanks.

The blank of steel connecting rods is usually produced by forging. There are two forms of blanks: one is to forge the body and the cover separately, and the other is to forge the body and the cover into one body and then cut during processing. In addition, in order to avoid defects in the connecting rod blank, hardness measurement and defect detection are required.

The small end of the connecting rod is connected to the piston through a piston pin, and the big end is connected to the crankshaft journal. The size of the big head and the small head depends on the pressure-bearing area. The operating temperature of the connecting rod is 90~100℃, and the operating speed is 3000~5000r/min. In order to ensure that the connecting rod forgings can smoothly enter the automated precision machining production line and ensure the assembly accuracy of the finished products in the engine, a high frequency of alternating tension and compression must be maintained.

Send Inquiry