How to complete the force verification of the hydraulic test bench? It goes through a series of steps to make the force value of the test machine meet the requirements of the corresponding standards. Usually, the operation is performed by the manufacturer and the Quality Supervision Bureau. Users do not need to master it, but need to understand it. The following is a detailed introduction to how the hydraulic test bench is operated.
1. Steps for force verification of the hydraulic test bench:
1. Enter the program as an administrator, and then open "Information Management" and "Sensor Verification";
2. Set the detection point and detection value, select the detection channel (the default is the forced channel), and select the number of detection groups (the default is three groups);
3. Click "Confirm" on the "Verification Point Setting" page to enter the verification;
4. Turn on the oil pump, and then click "Run" on the operation control panel.

Fanghe Machinery
5. When the load of the hydraulic test bench approaches the calibration (verification) point, manually control the slow speed (if it is automatically loaded, please click the slow button in the "Verification Interface"), and when it reaches the calibration (verification) point, click the "space bar" on the keyboard to record this point;
6. Repeat step 5 and record the points that need to be calibrated (verified) in turn;
7. After a set of calibration is completed, the hydraulic test bench program will automatically stop running (click "End") to exit the calibration interface and enter the "Display Verification Results" interface), click "Run" again for the next set of verification;
8. After three sets of verification, the program will automatically exit the "Display Verification Results" interface.
Check the calibration error. If the error exceeds the standard, please modify the calibration code.
The hydraulic test bench uses hydraulic jaws under the cylinder body to adjust the test space. The micro-electro-hydraulic servo fully digital closed-loop control system is applied, and the loading speed can be freely set. The detection uses imported high-precision sensors, which can dynamically display the resultant force value, displacement, deformation, and computer monitoring test data and curves under constant stress conditions. The hydraulic test bench can also print out test data editing, curve preview, storage, network connection and all necessary test reports and curves.






