The connecting rod group consists of connecting rod body, connecting rod big end cover, connecting rod small end bushing, connecting rod big end bearing bushing and connecting rod bolt (or screw). The connecting rod group bears the gas force transmitted from the piston pin and its own swing and the reciprocating inertia force of the piston group. The magnitude and direction of these forces change regularly. Therefore, the connecting rod bears alternating loads such as compression and tension, and must have sufficient fatigue strength and structural stiffness. Insufficient fatigue strength usually leads to the fracture of the connecting rod body or connecting rod bolt, which in turn causes major accidents such as damage to the whole machine. If the stiffness is insufficient, the rod body will bend and deform, and the big end of the connecting rod will deform, resulting in eccentric wear of the piston, cylinder, bearing and crank pin.
The connecting rod body consists of three parts. The part connected to the piston pin is called the connecting rod small end. The part connected to the crankshaft is called the connecting rod big end, and the connecting rod connecting the small end to the big end is called the connecting rod shaft.
The small end of the connecting rod is mostly a thin-walled circular ring structure. In order to reduce the wear between the piston pins, a thin-walled bronze bushing is pressed into the small top hole, and grooves are drilled or milled on the small head and bushing to allow the splashing oil to enter the mating surface of the lubricating bushing and the piston pin.
The connecting rod shaft is a long rod, and the force is relatively large. In order to prevent it from bending and deformation, the shaft must have sufficient rigidity. Therefore, most connecting rod shafts of vehicle engines use an I-shaped cross section. The cross section of high-strength engines is H-shaped. Some engines use the small end of the connecting rod to spray oil to cool the piston, and a through hole will be drilled in the longitudinal direction of the shaft. In order to avoid stress concentration, the connection between the connecting rod shaft and the small end and the large end adopts a larger arc smooth transition.
In order to reduce the vibration of the engine, the quality difference of the connecting rod of each cylinder needs to be limited to a relatively small range. When assembling the engine in the factory, the unit of measurement is usually based on the quality of the large and small connecting rods, and the same engine is selected. And group connecting rods.







